Data Burner Wizard

To burn data:

1. Insert a disc into the drive, if you have not done it yet. Click Refresh. Select a burner from the list (the one you have inserted disc in).

2. Click Next to continue.

3. Select a type of the file system. The default file system type is ISO9660 + Joliet  extensions. Other available file systems are ISO 9660 Level 1, ISO 9660 Level 2 and UDF.

4. Click Next to continue.

5. If you need to create a bootable disc, select the appropriate checkbox and specify the required information.

6. Click Next to continue.

7. Create a list of files and directories to burn using the drag-and-drop method.

Note: The default disc label is New. To change a disc label, either right-click the disc root and select Rename, or click the disc root and then click F2.

8. Click Next to continue.

9. Select a burning mode and if needed enable Test mode and/or the Verify written data option.

Note: Test mode performs all steps of burning with a low-power laser without actually writing data. Therefore, it allows for error checking and prevents damage of a media.

The Verify written data option ensures that data has been written properly. It launches verification process right after disc burning.

10. Click Next to continue.

11. If needed, select the Send optimum power calibration (OPC) checkbox to provide higher quality burning.

Specify the desired speed from the list of supported burning speeds.

You can also enable new burn sessions on this disc later by clicking Create multisession disc.

12. Click Next to continue.

13. Review the Options Summary page and make sure all options are correct. Click Back to make any changes on previous pages.

14. Click Next to continue.

15. Wait until the burning process is completed.

16. When burning is completed, you can save the log if needed.

Note: Click Save Log to save the current operation log. If there are any burning problems, use the Send Report options to send a failed operation log to the support team.

17. Click Finish to exit the wizard.