Audio Burner Wizard

starburnsoftware.com

To burn audio:

1. Insert a disc into the drive, if you have not done it yet. Click Refresh. Select a burner from the list (the one you have inserted disc in).

2. Click Next to continue.

3. Create a list of files and directories to burn using Add File(s), Remove and Remove All buttons. Alternatively, use the drag-and-drop method.

Note: The supported files types are PCM, 44100 Hz, 16 bit, stereo (wav), MPEG1 Layer 3 (mp3), Windows Media Audio (wma), OGG Vorbis (ogg) etc.

4. Click Next to continue.

5. Select a burning mode. The default mode is Disc-At-Once raw P-W that enables writing CD-Text information (Artist and Title) for each track. Alternatively, you can select one of the following burning modes: Disc-At-Once PQ, Session-At-Once and Track-At-Once.

6. Click Next to continue.

7. If needed, select the Send optimum power calibration (OPC) checkbox to provide higher quality burning.

Specify the desired speed from the list of supported burning speeds.

8. Click Next to continue.

9. Review the Options Summary page and make sure all options are correct. Click Back to make any changes on previous pages.

10. Click Next to begin burning.

11. Wait until Audio CD burning is completed.

12. When burning is completed, you can save the log if needed.

Note: Click Save Log to save the current operation log. If there are any burning problems, use the Send Report options to send a failed operation log to the support team.

13. Click Finish to exit the wizard.